Codey OnlineBiblioteca de componentes Arduino y ESP32 › TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision
TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision
Sensores

TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

El módulo TOF200C utiliza el sensor láser de distancia time-of-flight ST VL53L0X para medir la distancia cronometrando la luz reflejada. Normalmente se conecta por un bus I2C para que microcontroladores como Arduino o ESP32 puedan leerlo.

Ancho: 21.5 mm

Pinout — TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

Pin Señal Descripción
VIN power Module power input for the VL53L0X board, typically supplied from 3.3–5V depending on module regulator.
GND ground Ground reference for power and I2C signals.
SDA SDA I2C data line for reading distance measurements from the VL53L0X.
SCL SCL I2C clock line driven by the host controller for VL53L0X communication.
INT interrupt Interrupt output from the VL53L0X, used to signal measurement/data-ready events.
SHUT enable Shutdown/reset control input for the VL53L0X; drive low to disable or reset the sensor.

Esquema de cableado de ejemplo — TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

Desde Hasta Cable
board:5V x1:VIN red
board:GND x1:GND black
board:A4 x1:SDA green
board:A5 x1:SCL blue

Código Arduino de ejemplo — TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

Este ejemplo se escribió y verificó por compilación para arduino-uno. Codey Online lo adapta a cualquier otra placa compatible.

#include <Wire.h>
#include <Adafruit_VL53L0X.h>

Adafruit_VL53L0X lox;
VL53L0X_RangingMeasurementData_t measure;

void setup() {
  Serial.begin(115200);
  while (!Serial) {
    ;
  }

  Wire.begin();

  Serial.println("Adafruit VL53L0X distance sensor example");

  if (!lox.begin()) {
    Serial.println("Failed to boot VL53L0X. Check wiring.");
    while (1) {
      delay(10);
    }
  }

  Serial.println("VL53L0X ready.");
}

void loop() {
  lox.rangingTest(&measure, false);

  if (measure.RangeStatus != 4) {
    Serial.print("Distance: ");
    Serial.print(measure.RangeMilliMeter);
    Serial.println(" mm");
  } else {
    Serial.println("Out of range");
  }

  delay(200);
}

Componentes relacionados

18650 Battery Shield with USB-C Charger and 5V Boost Converter

18650 Battery Shield with USB-C Charger and 5V Boost Converter

2.4 inch OLED Display I2C 3.3V

2.4 inch OLED Display I2C 3.3V

3.5 inch TFT LCD Shield

3.5 inch TFT LCD Shield

50kg Load Cell Weight Sensor

50kg Load Cell Weight Sensor

Crea tu proyecto de Arduino o ESP32 con IA

Describe lo que quieres construir. Codey Online escribe el codigo, dibuja el esquema de conexiones, lo compila y graba tu placa directamente desde el navegador.

Empieza gratis