Codey OnlineBibliothèque de composants Arduino & ESP32 › TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision
TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision
Capteurs

TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

Le module TOF200C utilise le capteur laser de mesure de distance à temps de vol ST VL53L0X pour mesurer la distance en chronométrant la lumière réfléchie. Il est généralement relié via un bus I2C afin de pouvoir être lu par des microcontrôleurs comme Arduino ou ESP32.

Largeur: 21.5 mm

Brochage — TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

Broche Signal Description
VIN power Module power input for the VL53L0X board, typically supplied from 3.3–5V depending on module regulator.
GND ground Ground reference for power and I2C signals.
SDA SDA I2C data line for reading distance measurements from the VL53L0X.
SCL SCL I2C clock line driven by the host controller for VL53L0X communication.
INT interrupt Interrupt output from the VL53L0X, used to signal measurement/data-ready events.
SHUT enable Shutdown/reset control input for the VL53L0X; drive low to disable or reset the sensor.

Exemple de schéma de câblage — TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

De Vers Fil
board:5V x1:VIN red
board:GND x1:GND black
board:A4 x1:SDA green
board:A5 x1:SCL blue

Exemple de code Arduino — TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

Cet exemple a été écrit et vérifié à la compilation pour le arduino-uno. Codey Online l'adapte pour vous à toute autre carte prise en charge.

#include <Wire.h>
#include <Adafruit_VL53L0X.h>

Adafruit_VL53L0X lox;
VL53L0X_RangingMeasurementData_t measure;

void setup() {
  Serial.begin(115200);
  while (!Serial) {
    ;
  }

  Wire.begin();

  Serial.println("Adafruit VL53L0X distance sensor example");

  if (!lox.begin()) {
    Serial.println("Failed to boot VL53L0X. Check wiring.");
    while (1) {
      delay(10);
    }
  }

  Serial.println("VL53L0X ready.");
}

void loop() {
  lox.rangingTest(&measure, false);

  if (measure.RangeStatus != 4) {
    Serial.print("Distance: ");
    Serial.print(measure.RangeMilliMeter);
    Serial.println(" mm");
  } else {
    Serial.println("Out of range");
  }

  delay(200);
}

Composants similaires

18650 Battery Shield with USB-C Charger and 5V Boost Converter

18650 Battery Shield with USB-C Charger and 5V Boost Converter

2.4 inch OLED Display I2C 3.3V

2.4 inch OLED Display I2C 3.3V

3.5 inch TFT LCD Shield

3.5 inch TFT LCD Shield

50kg Load Cell Weight Sensor

50kg Load Cell Weight Sensor

Construisez votre projet Arduino ou ESP32 avec l'IA

Décrivez ce que vous voulez créer. Codey Online écrit le code, dessine le schéma de câblage, le compile et flashe votre carte directement depuis le navigateur.

Commencez gratuitement