Codey OnlineLibreria di componenti Arduino ed ESP32 › 3-Channel 5V Relay Module
3-Channel 5V Relay Module
Output

3-Channel 5V Relay Module

Questo è un modulo relè per controllare carichi esterni da un microcontrollore usando pin di ingresso digitali. Si alimenta da VCC e GND, e i canali del relè sono pilotati dai pin IN per un commutamento isolato on/off di circuiti a potenza maggiore.

Larghezza: 50.6 mm

Pinout — 3-Channel 5V Relay Module

Pin Segnale Descrizione
GND ground Logic ground reference for the relay module control inputs
IN1 digital Active-low control input for relay 1 — drive low to energize
IN2 digital Active-low control input for relay 2 — drive low to energize
IN3 digital Active-low control input for relay 3 — drive low to energize
VCC power 5V logic/module supply input for relay control circuitry
GND.1 ground Additional ground connection for the relay module logic side

Schema di cablaggio di esempio — 3-Channel 5V Relay Module

Da A Filo
board:GND x1:GND black
board:5V x1:VCC red
board:D4 x1:IN1 green
board:D5 x1:IN2 blue
board:D6 x1:IN3 yellow

Codice Arduino di esempio — 3-Channel 5V Relay Module

Questo esempio è stato scritto e verificato in compilazione per arduino-uno. Codey Online lo adatta a qualsiasi altra scheda supportata.

const int RELAY1_PIN = 4;
const int RELAY2_PIN = 5;
const int RELAY3_PIN = 6;

void setup() {
  Serial.begin(9600);
  pinMode(RELAY1_PIN, OUTPUT);
  pinMode(RELAY2_PIN, OUTPUT);
  pinMode(RELAY3_PIN, OUTPUT);

  // Most 5V relay modules are active-low:
  // HIGH = relay off, LOW = relay on.
  digitalWrite(RELAY1_PIN, HIGH);
  digitalWrite(RELAY2_PIN, HIGH);
  digitalWrite(RELAY3_PIN, HIGH);

  Serial.println("3-Channel Relay Module demo starting...");
}

void loop() {
  Serial.println("Relay 1 ON");
  digitalWrite(RELAY1_PIN, LOW);
  delay(1000);
  digitalWrite(RELAY1_PIN, HIGH);

  Serial.println("Relay 2 ON");
  digitalWrite(RELAY2_PIN, LOW);
  delay(1000);
  digitalWrite(RELAY2_PIN, HIGH);

  Serial.println("Relay 3 ON");
  digitalWrite(RELAY3_PIN, LOW);
  delay(1000);
  digitalWrite(RELAY3_PIN, HIGH);

  Serial.println("All relays OFF");
  delay(1000);
}

Componenti correlati

18650 3.7V Li-Ion Battery

18650 3.7V Li-Ion Battery

3W amplifier MAX98357A I2S DAC

3W amplifier MAX98357A I2S DAC

8-Channel Relay Module

8-Channel Relay Module

Active Buzzer Module

Active Buzzer Module

Crea il tuo progetto Arduino o ESP32 con l'AI

Descrivi cosa vuoi realizzare. Codey Online scrive il codice, disegna lo schema di collegamento, lo compila e programma la tua scheda direttamente dal browser.

Inizia gratis