Codey OnlineLibreria di componenti Arduino ed ESP32 › TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision
TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision
Sensori

TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

Il modulo TOF200C usa il sensore laser di distanza time-of-flight ST VL53L0X per misurare la distanza cronometrando la luce riflessa. In genere si collega tramite bus I2C, così può essere letto da microcontrollori come Arduino o ESP32.

Larghezza: 21.5 mm

Pinout — TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

Pin Segnale Descrizione
VIN power Module power input for the VL53L0X board, typically supplied from 3.3–5V depending on module regulator.
GND ground Ground reference for power and I2C signals.
SDA SDA I2C data line for reading distance measurements from the VL53L0X.
SCL SCL I2C clock line driven by the host controller for VL53L0X communication.
INT interrupt Interrupt output from the VL53L0X, used to signal measurement/data-ready events.
SHUT enable Shutdown/reset control input for the VL53L0X; drive low to disable or reset the sensor.

Schema di cablaggio di esempio — TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

Da A Filo
board:5V x1:VIN red
board:GND x1:GND black
board:A4 x1:SDA green
board:A5 x1:SCL blue

Codice Arduino di esempio — TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

Questo esempio è stato scritto e verificato in compilazione per arduino-uno. Codey Online lo adatta a qualsiasi altra scheda supportata.

#include <Wire.h>
#include <Adafruit_VL53L0X.h>

Adafruit_VL53L0X lox;
VL53L0X_RangingMeasurementData_t measure;

void setup() {
  Serial.begin(115200);
  while (!Serial) {
    ;
  }

  Wire.begin();

  Serial.println("Adafruit VL53L0X distance sensor example");

  if (!lox.begin()) {
    Serial.println("Failed to boot VL53L0X. Check wiring.");
    while (1) {
      delay(10);
    }
  }

  Serial.println("VL53L0X ready.");
}

void loop() {
  lox.rangingTest(&measure, false);

  if (measure.RangeStatus != 4) {
    Serial.print("Distance: ");
    Serial.print(measure.RangeMilliMeter);
    Serial.println(" mm");
  } else {
    Serial.println("Out of range");
  }

  delay(200);
}

Componenti correlati

18650 Battery Shield with USB-C Charger and 5V Boost Converter

18650 Battery Shield with USB-C Charger and 5V Boost Converter

2.4 inch OLED Display I2C 3.3V

2.4 inch OLED Display I2C 3.3V

3.5 inch TFT LCD Shield

3.5 inch TFT LCD Shield

50kg Load Cell Weight Sensor

50kg Load Cell Weight Sensor

Crea il tuo progetto Arduino o ESP32 con l'AI

Descrivi cosa vuoi realizzare. Codey Online scrive il codice, disegna lo schema di collegamento, lo compila e programma la tua scheda direttamente dal browser.

Inizia gratis