Codey OnlineArduino- & ESP32-componentenbibliotheek › TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision
TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision
Sensoren

TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

De TOF200C-module gebruikt de ST VL53L0X time-of-flight lasersensor om afstand te meten door de teruggekaatste lichtpuls te timen. Je sluit hem meestal aan via een I2C-bus, zodat microcontrollers zoals Arduino of ESP32 hem kunnen uitlezen.

Breedte: 21.5 mm

Pinout — TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

Pin Signaal Beschrijving
VIN power Module power input for the VL53L0X board, typically supplied from 3.3–5V depending on module regulator.
GND ground Ground reference for power and I2C signals.
SDA SDA I2C data line for reading distance measurements from the VL53L0X.
SCL SCL I2C clock line driven by the host controller for VL53L0X communication.
INT interrupt Interrupt output from the VL53L0X, used to signal measurement/data-ready events.
SHUT enable Shutdown/reset control input for the VL53L0X; drive low to disable or reset the sensor.

Voorbeeld-aansluitschema — TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

Van Naar Draad
board:5V x1:VIN red
board:GND x1:GND black
board:A4 x1:SDA green
board:A5 x1:SCL blue

Voorbeeld-Arduinocode — TOF200C VL53L0X Distance Sensor Time-Of-Flight high precision

Dit voorbeeld is geschreven en compile-gecheckt voor de arduino-uno. Codey Online past het voor je aan naar elk ander ondersteund board.

#include <Wire.h>
#include <Adafruit_VL53L0X.h>

Adafruit_VL53L0X lox;
VL53L0X_RangingMeasurementData_t measure;

void setup() {
  Serial.begin(115200);
  while (!Serial) {
    ;
  }

  Wire.begin();

  Serial.println("Adafruit VL53L0X distance sensor example");

  if (!lox.begin()) {
    Serial.println("Failed to boot VL53L0X. Check wiring.");
    while (1) {
      delay(10);
    }
  }

  Serial.println("VL53L0X ready.");
}

void loop() {
  lox.rangingTest(&measure, false);

  if (measure.RangeStatus != 4) {
    Serial.print("Distance: ");
    Serial.print(measure.RangeMilliMeter);
    Serial.println(" mm");
  } else {
    Serial.println("Out of range");
  }

  delay(200);
}

Vergelijkbare componenten

18650 Battery Shield with USB-C Charger and 5V Boost Converter

18650 Battery Shield with USB-C Charger and 5V Boost Converter

2.4 inch OLED Display I2C 3.3V

2.4 inch OLED Display I2C 3.3V

3.5 inch TFT LCD Shield

3.5 inch TFT LCD Shield

50kg Load Cell Weight Sensor

50kg Load Cell Weight Sensor

Bouw je Arduino- of ESP32-project met AI

Beschrijf wat je wilt bouwen. Codey Online schrijft de code, tekent het aansluitschema, compileert het en flasht je board rechtstreeks vanuit de browser.

Gratis starten