Este módulo contiene dos relés electromecánicos para conmutar cargas externas desde un microcontrolador de bajo consumo. Normalmente se controla mediante entradas lógicas y se alimenta con 12V para las bobinas de los relés, lo que permite el aislamiento entre la parte de control y el circuito conmutado.
| Pin | Señal | Descripción |
|---|---|---|
NO1 |
Normally-open contact for relay 1; connects to COM1 when relay 1 energizes. | |
COM1 |
Common switched terminal for relay 1 load circuit. | |
NC1 |
Normally-closed contact for relay 1; connected to COM1 when relay is off. | |
NO2 |
Normally-open contact for relay 2; connects to COM2 when relay 2 energizes. | |
COM2 |
Common switched terminal for relay 2 load circuit. | |
NC2 |
Normally-closed contact for relay 2; connected to COM2 when relay is off. | |
DC+ |
power | 12V positive supply input for the relay module coils and driver circuitry. |
DC- |
ground | Power ground/negative supply reference for the relay module control side. |
IN1 |
digital | Control input for relay 1; drive from MCU logic to switch channel 1. |
IN2 |
digital | Control input for relay 2; drive from MCU logic to switch channel 2. |
Describe lo que quieres construir. Codey Online escribe el codigo, dibuja el esquema de conexiones, lo compila y graba tu placa directamente desde el navegador.
Empieza gratis
