Codey Online › Placas Arduino y ESP32 compatibles › Arduino UNO R4 WiFi
Arduino UNO R4 WiFi
Arduino

Arduino UNO R4 WiFi

Renesas RA4M1 (Cortex-M4 48 MHz, 256 KB flash, 32 KB SRAM) con matriz LED 12x8 integrada, coprocesador ESP32-S3 WiFi/BLE y conector Qwiic. Nivel de señal de 5V en los headers UNO mediante level shifter; internamente, el RA4M1 es un chip de 3,3V.

Destino de compilación (FQBN): arduino:renesas_uno:unor4wifi Pinout: 31

Pinout — Arduino UNO R4 WiFi

Pin Señal Descripción
AREF reference Analog reference voltage for the ADC; usually externally filtered or left unused
GND ground Ground return for signals and power
D13 digital Digital I/O, also the onboard LED/SCK-capable pin
D12 digital Digital I/O; commonly used as SPI MISO
D11 PWM Digital I/O; PWM-capable and commonly used as SPI MOSI
D10 PWM Digital I/O; PWM-capable and often used as SPI chip select
D9 PWM Digital I/O; PWM-capable general-purpose pin
D8 digital Digital I/O; general-purpose pin
D7 digital Digital I/O; general-purpose pin
D6 PWM Digital I/O; PWM-capable general-purpose pin
D5 PWM Digital I/O; PWM-capable general-purpose pin
D4 digital Digital I/O; general-purpose pin
D3 PWM Digital I/O; PWM-capable general-purpose pin
D2 interrupt Digital I/O; interrupt-capable general-purpose pin
IOREF reference Board I/O voltage reference; indicates 5V-level UNO header logic
RESET reset Active-low reset input for the RA4M1 and board logic
3.3V power-low Regulated 3.3V output for low-power peripherals
5V power 5V supply rail for external shields and devices
GND.1 ground Ground return for power and signals
GND.2 ground Ground return for power and signals
VIN power-high External input supply for the onboard regulator
A0 analog Analog input to the RA4M1 ADC; also usable as digital I/O
A1 analog Analog input to the RA4M1 ADC; also usable as digital I/O
A2 analog Analog input to the RA4M1 ADC; also usable as digital I/O
A3 analog Analog input to the RA4M1 ADC; also usable as digital I/O
A4 SDA Analog input and shared I2C SDA line; also on the Qwiic connector
A5 SCL Analog input and shared I2C SCL line; also on the Qwiic connector
D1 TX Digital I/O; igeneral-purpose pin; TX
D0 RX Digital I/O; igeneral-purpose pin; RX
SCL SCL Analog input and shared I2C SCL line; also on the Qwiic connector
SDA SDA Analog input and shared I2C SDA line; also on the Qwiic connector

Notas de cableado

Los headers se comportan eléctricamente como 5V (level shifter a 3,3V internamente). La matriz LED integrada es un componente de hardware aparte que se controla con Arduino_LED_Matrix; no se debe cablear como un componente externo. El conector Qwiic comparte SDA/SCL con A4/A5.

Crea tu proyecto de Arduino o ESP32 con IA

Describe lo que quieres construir. Codey Online escribe el codigo, dibuja el esquema de conexiones, lo compila y graba tu placa directamente desde el navegador.

Empieza gratis